Need help finding wear parts references or proper methods for adjusting your Bandit Wood Chipper or Stump Grinder? Below are reference materials and helpful videos for operating and maintaining your equipment.

Contact your local ACT parts representative for the wear parts you need to keep your Bandit machine running great!

Bandit Hand Fed Chipper Knives feature high quality dual edge designs that can be used on both edges. When one side becomes unusable, the knife can be flipped and used on the other edge. Only Bandit knives and hardware are recommended for use in a Bandit chipper. Only then can you be assured of a quality product that fits and performs to the best standards of excellence that is expected from a Bandit chipper. Chipper knives MUST be always kept sharp for the ultimate chipper and knife performance. The main cause of poor cutting performance is dull knives.

Dull Knives Cause:

  • Excessive wear on engine
  • Bad quality chips (chunks, slivers)
  • Strain on knives and mounting hardware
  • Strain on chipper disc/drum bearings
  • Can cause vibration
  • Increases the probability of plugging the discharge chute
  • Loss of time and productivity

Bandit Wood Chipper Wear Parts Reference Sheets:

Bandit Stump Grinder Wear Parts Reference Sheets:

Videos to help you Maintain your Bandit Machine:

Adjusting and changing knives on your Bandit Hand fed Wood Chipper
Anvil adjustment on Bandit Hand Fed Wood Chippers
Belt Adjustment on Bandit Hand Fed Wood Chippers
Adjusting the Shear Bar on Bandit Hand Fed Wood Chippers
Adjusting the clutch on Bandit Hand Fed Wood Chippers